Kitchen  /  Service

Faucet and Sink Installation in Santa Rosa, California

New kitchen faucets and sinks with solid mounts and carefully checked connections.

I install kitchen faucets and drop-in sinks around Santa Rosa and Bennett Valley: out with the old one, in with the new, and supply and drain lines reconnected. Like-for-like swaps are handyman work. If a job needs lines moved or a licensed plumber, I’ll tell you.

Faucet and Sink Installation in Santa Rosa

A sink and faucet that work every day

Looking for kitchen faucet or sink installation in Santa Rosa? I take out the old fixture, clean up the surface underneath, set the new faucet or sink with the right seals, and reconnect supply and drain lines. Then I run the water and check every connection before I pack up.

Faucet and Sink Installation, close-up example
Faucet and Sink Installation, example

The tricky part of a faucet swap is usually under the sink, not on top. Old mounting nuts can be corroded in place, shutoff valves can stick, and the existing supply lines may not suit the new faucet. I test the shutoffs before starting so the water goes off cleanly and comes back on cleanly.

Drop-in sinks are in scope, and so are many undermount situations. Stone counters with unusual cutouts may need templating or fabrication beyond handyman work. I’ll say so if your photos show it.

What to have ready

Pick out the faucet or sink before I come, or send me the link and I’ll look at it with you. Count the holes in your sink or counter (one, two, three or four) and compare that to what the new faucet needs. A deck plate can cover extra holes on many models.

Send photos of the top of the sink, the whole cabinet underneath with the doors open, and a close-up of the shutoff valves. That shows me the drain layout, what else is connected under there, and how much room there is to work. Clearing out the sink cabinet before I arrive helps too.

Some jobs are bigger than a swap. Moving a sink to a new spot, adding new supply or drain lines, replacing corroded pipe inside the wall, or cutting a counter for a different sink all need a licensed plumber or a countertop fabricator. I’ll flag those early so you’re not surprised.

Kitchen faucet and sink swaps done right.

What I handle

  • Kitchen faucet replacement
  • Pull-down and pull-out faucet installs
  • Drop-in sink installation
  • New supply lines to existing shutoffs
  • Drain reconnection to the existing layout
  • Soap dispenser installs when applicable
  • Sealant, leak check and cleanup
Next step

Ready to get started?

Send a few photos or a short description of what you need. I’ll reply with clear next steps and an upfront estimate.

Request an Estimate
Common questions

Faucet and Sink Installation FAQ

Do I buy the faucet, or do you?

Usually you buy it, so you get exactly the finish and style you want. Send me the model before you order and I’ll check it against your sink and shutoffs.

My sink has more holes than the new faucet needs. Is that a problem?

Not usually. Many faucets come with a deck plate or offer one to cover the extra holes, and a spare hole can sometimes hold a soap dispenser.

What if my shutoff valves don’t work?

I test them before starting. If one won’t close or starts leaking, I’ll stop and talk it through with you, since replacing it may be a job for a licensed plumber depending on the pipe.

Can you swap my drop-in sink for an undermount?

That usually means cutting or reworking the countertop, which is fabricator work rather than handyman work. Replacing a drop-in with another drop-in of a similar size is a much simpler job.

Can you replace the sink strainer or drain parts while you’re under there?

Yes, if they’re worn or leaking. It’s easier to replace them while the sink is already apart than to come back later.

Do I need to empty the cabinet under the sink?

It helps. I need room to get under the sink and reach the connections, so clearing it out before I arrive saves time.